eze10x005-model-eze10x005-eze10x005-tecsis-analogue-strain-gauge-measurement-amplifier-tecsis-viet-nam.png

EZE10X005, Model EZE10X005, EZE10X005 Tecsis, Analogue Strain Gauge Measurement Amplifier Tecsis Việt Nam

Nhà cung cấp: pites

Hãng sản xuất: Tecsic

Liên hệ tư vấn

Mr Hà

ha@pitesco.com

0392.407.993

ha@pitesco.com

EZE10X005, Model EZE10X005, EZE10X005 Tecsis, Analogue Strain Gauge Measurement Amplifier Tecsis Việt Nam

 

Features

  • Strain gauge amplifier to be mounted on printed circuit boards or top hat rails
  • Outputsignal ±10 V (3-Wire)
  • Accuracy 0.01% of full scale
  • Limit frequency up to 3.3 kHz (-3db) for highly dynamic applications
  • Can be used with strain gauges with a resistance starting at 350 ohm
  • Needed power supply 12-24 VDC
  • Pluggable through integrated connection strip
  • Space-saving housing
  • Micro-switch to adjust zero point, span and filter
  • Protection Class IP 40

Application

Developed for fast and accurate force measurement the model EZE10X005 amplifier can be used in all kinds of dynamic force measurement applications. It is possible to connect all kind of strain gauges to the amplifier (up to 1 sensor with a resistance of 350 ohm) with an output signal up to ± 3,2 mV/V. The internal sensor supply is 10 VDC. Usually the amplifier is not pre-adjusted and the customer connects it to the force transducer and also adjusts it. Because of the 3-wire analogue output of ± 10 V and the needed supply energy for the amplifier between 12 and 24 V it is possbile to connect the model EZE10X005 series directly to PLC. Those normaly come with matching analogue inputs which offer a supply energy of 24 V. The integrated connection strip allows to plug the amplifier onto a circuit board. An adapterboard with screw-terminals for top hat mounting according to DIN EN 50022 in enclosures is available. Although usually there is no accurate adjusted signal needed for PLCs the adaptorboard is also available with potentiometer, which allows accurate signal adjustment. Interfering signals can be damped by a low-pass filter.